Sharp Mebius PC-MM1-H3Eのdmesg出力


Linux version 2.4.22-pre2 (root@localhost.localdomain) (gcc バージョン 3.2.2 20030222 (Red Hat Linux 3.2.2-5)) #9 2003年 6月 29日 日曜日 13:34:07 JST
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009ac00 (usable)
 BIOS-e820: 000000000009ac00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000dc000 - 00000000000e0000 (reserved)
 BIOS-e820: 00000000000e4000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000000e6f0000 (usable)
 BIOS-e820: 000000000e6f0000 - 000000000e6ff000 (ACPI data)
 BIOS-e820: 000000000e6ff000 - 000000000e700000 (ACPI NVS)
 BIOS-e820: 000000000e700000 - 000000000e800000 (usable)
 BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
232MB LOWMEM available.
ACPI: have wakeup address 0xc0001000
On node 0 totalpages: 59392
zone(0): 4096 pages.
zone(1): 55296 pages.
zone(2): 0 pages.
ACPI: RSDP (v000 PTLTD                      ) @ 0x000f7470
ACPI: RSDT (v001 PTLTD    RSDT   01540.00005) @ 0x0e6fbe24
ACPI: FADT (v001 TMETA  PDB.ALI  01540.00005) @ 0x0e6fef8c
ACPI: DSDT (v001 PTLTD  DSDT     01540.00005) @ 0x00000000
ACPI: BIOS passes blacklist
Kernel command line: ro root=LABEL=/
Initializing CPU#0
Detected 993.301 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1933.31 BogoMIPS
Memory: 232164k/237568k available (1316k kernel code, 4932k reserved, 514k data, 120k init, 0k highmem)
Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 512K (128 bytes/line)
CPU: Processor revision 1.5.0.2, 1000 MHz
CPU: Code Morphing Software revision 4.3.4-9-540
CPU: 20021104 07:53 official release 4.3.4#1
CPU:     After generic, caps: 0080893f 0081813f 000000ce 00000000
CPU:             Common caps: 0080893f 0081813f 000000ce 00000000
CPU: Transmeta(tm) Crusoe(tm) Processor TM5800 stepping 03
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: none
ACPI: Subsystem revision 20030619
PCI: PCI BIOS revision 2.10 entry at 0xfd8ae, last bus=0
PCI: Using configuration type 1
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: System [ACPI] (supports S0 S3 S4 S5)
ACPI: PCI Root Bridge [PCI0] (00:00)
PCI: Probing PCI hardware (bus 00)
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Link [LNK1] (IRQs *10)
ACPI: PCI Interrupt Link [LNK2] (IRQs 10, disabled)
ACPI: PCI Interrupt Link [LNK3] (IRQs *5)
ACPI: PCI Interrupt Link [LNK4] (IRQs *11)
ACPI: PCI Interrupt Link [LNK5] (IRQs *3)
ACPI: PCI Interrupt Link [LNK6] (IRQs *4)
ACPI: PCI Interrupt Link [LNKM] (IRQs 3 4 5 7 9 10 11, disabled)
ACPI: PCI Interrupt Link [LNKA] (IRQs *9)
ACPI: PCI Interrupt Link [LNKU] (IRQs 3 4 5 7 9 10 11, disabled)
PCI: Probing PCI hardware
ACPI: PCI Interrupt Link [LNK2] enabled at IRQ 10
ACPI: PCI Interrupt Link [LNKM] enabled at IRQ 11
ACPI: PCI Interrupt Link [LNKU] enabled at IRQ 9
PCI: No IRQ known for interrupt pin A of device 00:10.0 - using IRQ 255
PCI: Using ACPI for IRQ routing
PCI: if you experience problems, try using option 'pci=noacpi' or even 'acpi=off'
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
VFS: Diskquotas version dquot_6.4.0 initialized
ACPI: AC Adapter [ADP1] (on-line)
ACPI: Battery Slot [BAT0] (battery present)
ACPI: Power Button (FF) [PWRF]
ACPI: Lid Switch [LID]
ACPI: Processor [CPU0] (supports C1 C2 C3)
ACPI: Thermal Zone [THRM] (63 C)
Asus Laptop ACPI Extras version 0.24a
pty: 512 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
Real Time Clock Driver v1.10e
floppy0: no floppy controllers found
NET4: Frame Diverter 0.46
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller at PCI slot 00:10.0
PCI: No IRQ known for interrupt pin A of device 00:10.0 - using IRQ 255
ALI15X3: chipset revision 196
ALI15X3: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0x1800-0x1807, BIOS settings: hda:DMA, hdb:pio
ALI15X3: simplex device: DMA forced
    ide1: BM-DMA at 0x1808-0x180f, BIOS settings: hdc:DMA, hdd:DMA
hda: TOSHIBA MK1503GAL, ATA DISK drive
blk: queue c0312f80, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 29297520 sectors (15000 MB), CHS=1823/255/63, UDMA(100)
ide-floppy driver 0.99.newide
Partition check:
 hda: hda1 hda2 hda3
ide-floppy driver 0.99.newide
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 32768)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 145k freed
VFS: Mounted root (ext2 filesystem).
Journalled Block Device driver loaded
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 120k freed
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-ohci.c: USB OHCI at membase 0xc00d9000, IRQ 5
usb-ohci.c: usb-00:0c.0, NEC Corporation USB
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 1 port detected
usb-ohci.c: USB OHCI at membase 0xc00da000, IRQ 5
usb-ohci.c: usb-00:0c.1, NEC Corporation USB (#2)
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 1 port detected
ehci_hcd 00:0c.2: NEC Corporation USB 2.0
ehci_hcd 00:0c.2: irq 11, pci mem cf053400
usb.c: new USB bus registered, assigned bus number 3
ehci_hcd 00:0c.2: USB 2.0 enabled, EHCI 0.95, driver 2003-Jun-19/2.4
hub.c: USB hub found
hub.c: 2 ports detected
usb.c: registered new driver hiddev
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik 
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,2), internal journal
Adding Swap: 489972k swap-space (priority -1)
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
ip_tables: (C) 2000-2002 Netfilter core team
8139too Fast Ethernet driver 0.9.26
divert: allocating divert_blk for eth0
eth0: RealTek RTL8139 Fast Ethernet at 0xcf0ab000, 08:00:1f:b1:bd:c9, IRQ 3
eth0:  Identified 8139 chip type 'RTL-8139C'
ip_tables: (C) 2000-2002 Netfilter core team
eth0: Setting half-duplex based on auto-negotiated partner ability 0000.
hermes.c: 4 Dec 2002 David Gibson 
orinoco.c 0.13b (David Gibson  and others)
orinoco_pci.c 0.13b (David Gibson  & Jean Tourrilhes )
Detected Orinoco/Prism2 PCI device at 00:0b.0, mem:0xFC104000 to 0xFC104FFF -> 0xcf0bc000, irq:4
Reset done..........................................................................................................................................................................................................................................................;
Clear Reset..................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................;
pci_cor : reg = 0x0 - 13B7 - 1385
divert: allocating divert_blk for eth1
eth1: Station identity 001f:0003:0001:0004
eth1: Looks like an Intersil firmware version 1.4.3
eth1: Ad-hoc demo mode supported
eth1: IEEE standard IBSS ad-hoc mode supported
eth1: WEP supported, 104-bit key
eth1: MAC address 00:02:8A:91:05:79
eth1: Station name "Prism  I"
eth1: ready
lp: driver loaded but no devices found